Windows 2016 OS deployment fails/stays in loop

Usage and Config OSD
1

Hi,

I am trying to install windows 2016 on VMWare vitual machine, but whenever it goes to Disk Clean-up step on BigFix OS Deployment console (after boot and DHCP address assignment), it failes with below error:

image.png704×389 36.3 KB

Once the count down for 10 seconds is completed on this screen it goes back to booting the VM and assigning IP address and fails again with the same error.

Anyone has idea what driver it is asking for?

2

Hi. At that stage of the deployment it it is missing the drivers to access the disk. You can check from the bindings tab of the driver library.

3

In the bindings tab I can see two drivers and there status is missing.

Do we need to import these drivers manually?

4

Hi.
1- You should use the middle tab instead. On a single model / Image is more accurate.
2- As the image you need to select WinPE as the error occurs while WinPE is running.

Then yes, you need to import the drivers manually.
hope this helps

5

Ok. I will try importing the drivers.

Thank you :slight_smile: