Return message

(imported topic written by mcalvi91)

We have some deployments where we need to return an message depending on the failure or success state of the task/fixlet. Can a command be added to return a non dynamic message upon failure or success?

we have done this previously with a reg key and a property but that seems a little kludgy.

MC

(imported comment written by BenKus)

Hey MC,

We expect to have return values incorporated in the product in the next major version. For now, the method of recording the values somewhere is the best I can think of.

Ben

(imported comment written by mcalvi91)

its on a roadmap so Im good. Thanks

(imported comment written by SystemAdmin)

Ben-

When you say next version, is that 8? Or is that a release further into the future? This is something that I have expressed interest in as well in another thread. Thanks.

(imported comment written by BenKus)

I believe it is in 8, but I will need to check to make sure it is still intended to be there…

Ben