Nmap scan

Usage and Config
1

(imported topic written by Cologne)

I am using the NMAP Scan Task and/or the wizard and in both cases i can’t discover any device ( i can ping the devices )

Route is 10.00.100.128 ( BES Server VMware WS Image ) - 10.100.100.1 ( my Windows 7 Host ) – 10.100.100.5 ( my windows xp VMware WS Image )

If i enter the nmap command manually, i am getting the following message:

Starting Nmap 5.21 ( http://nmap.org ) at 2010-09-27 08:42 W. Europe Daylight Time

Note: Host seems down. If it is really up, but blocking our ping probes, try -PN

Nmap done: 1 IP address (0 hosts up) scanned in 0.95 seconds

2

(imported comment written by BenKus)

Hi jochen,

Is the BigFix Agent installed on these devices?

Ben

3

(imported comment written by Cologne)

no, there is no BigFix Agent installed. i can not scan any server in my network with the nmap scan

Jochen

4

(imported comment written by SystemAdmin)

Hello Jochen, how are you?

Please take a look on this topic. It might help you out:

http://forum.bigfix.com/viewtopic.php?id=5707

I hope it helps.

Best regards,

Ricardo

5

(imported comment written by Cologne)

Thanks,

but how and where can i set the parm “ignorebesclients = 0”?

6

(imported comment written by SystemAdmin)

Ho Jochen,

It’s the ‘Change UAImporter Delete Mode’ task in the BES Asset Discovery site.