Issue with BES Client Setting: BESClientUI Enable Mode

Hi,

I have issue with installing “BES Client Setting: BESClientUI Enable Mode”. The system doesn’t seems to enabling the setting to the machine that I targeted to.
Fyi, the action was taken at 1313pm today but till now the status of this action is still “Not Reported”. Please advise.

You should have UDP traffic on BigFix port opened as well to get the client aware of new action waiting, so that it can evaluate and report back: https://help.hcltechsw.com/bigfix/10.0/platform/Platform/Installation/c_network_configuration.html
If UDP is not available, you can enable the polling on the client side: https://help.hcltechsw.com/bigfix/10.0/platform/Platform/Installation/c_sample_proxy_configurations.html

P.S. By restarting the client, you will force it to check if new content is available…

I have checked, until now, there is only 1 machine is enabled the BES Client Setting. The other 2 are still “Pending”

Did you check the UDP traffic is allowed from Relay to Client?