(imported topic written by amagewick91)
I would like to know how to apply a baseline with an action, keep the action open, modify the baseline after the computers are “complete” and have the clients see that there is a change and then run the baseline again.
I can’t seem to figure out how to get this to work.
(imported comment written by BenKus)
Hey amagewick,
By design, you will need to update the baseline, stop the baseline action, and then re-run the baseline. This is done to prevent unauthorized changes to your approved baselines and undesired side-effects from changing a baseline without realizing the consequences of the change.
Some more discussion of this topic is here:
http://forum.bigfix.com/viewtopic.php?id=2738
Ben
(imported comment written by amagewick91)
Can I run that action redeploy tool and just rerun an open action for the baseline… or is that for something else? Thank you for the info so far!
(imported comment written by BenKus)
I don’t the the redeploy will work properly for baselines… but in either case, I recommend re-running the action manually to make sure to select the appropriate action parameters.
Ben